Mold Remediation In San Diego

Molds can grow all over the place where water and moisture is present. In most cases, normal mold production happens indoors. Leaky roofs, dripping faucets and poor water containment procedures are some of the causes of mold growth in houses and office buildings. Moisture also plays a vital part in mold growth. In San Diego, California where the climate is characterized by warm and dry summers, the humidity rises to high levels, thus, trapping a large amount of moisture that can invite mold spores.

The presence of molds in your household must not be ignored; else, this could impose a serious threat not only to the physical structure of your abode, but also to the health of individuals. Mold contamination spreads harmful pollutants that can lead to allergies, headaches, upper respiratory illnesses and above all, cancer.

Several mold remediation techniques (San Diego Mold Removal) have been devised to kill and ultimately remove the molds from an indoor environment. Though sunlight and proper ventilation can be of help, they can only do much for normal occurrences of molds. For excessive mold growth, professional mold remediation workers employ the following techniques:

1. Use of specialized mold analysis equipments
Professional mode remediation (Encinitas Water Damage Removal) workers carry specialized equipments when they first analyze the presence of molds in the indoor environment. A Moisture Meter is used to measure the amount of moisture in the indoor environment. A Humidity Gauge, meanwhile, measures the amount of humidity. They also have a Borescope which is capable of seeing through the insides of walls, ceilings and other tight spaces that might be contain molds.

2. Use of wet vacuum cleaners
In order to remove the molds (San Diego Mold Remediation), the source of moisture must be taken out first. A wet vacuum is designed to suck out the water from floors, carpets and other surfaces that have been confined with water. After using this equipment (Oceanside Mold Removal), it must be cleaned and dried right away to prevent new mold spores from clinging to the vacuum.

3. Damp-wiping
Damp wipes such as rags and paper towels are used to remove the molds from metal, plastic, concrete and other non-porous surfaces. The rag must first be soaked (San Diego Water Damage Repair) in water with an anti-fungal detergent, and then scrub off the molds that are present on the surface.

4. Use of High Efficiency Particulate Air (HEPA) filtered vacuum cleaners.
Finally, HEPA-filtered vacuum cleaners are used when all of the surfaces have been dried up already. In this final stage of mold remediation, contaminated materials such as furnishings and fixtures must already be taken out. The HEPA-filtered vacuum will now be used to clean up the outside areas surrounding the remediation area. The debris that will be collected during this process must be put in a durable container and must be disposed right away.

No matter how large or small the extent of the damage is, it is still best to make use of the proper techniques (Carlsbad Mold Removal) in disposing the molds. Sufficient knowledge about molds remediation and getting the services of a professional (La Jolla Mold and Mildew Removal) is certainly a wise move to prevent the contamination from happening again.

Category : Uncategorized

Leave a Reply

You must be logged in to post a comment.